User Defined Program; Preset Programs - LifeSpan BOOMER PLUS User Manual

value is from 0.5 to 99:9.
4. When the distance is in the mode of counting down, press "DISPLAY MODE" and the
calories will begin to count down. The CAL window will display the flashing number
"50". Press the "SPEED+", "SPEED-" to set the desired distance. Setting value is from
10 to 999.
5. After setting, press START, the treadmill will start after 3 seconds. Press the "SPEED+",
"SPEED-" to change the incline and the speed. Press STOP to stop the treadmill.
6 .
EXERCISE IN INNER MODE
There are 24 manual mode P01-P24. Press "PROGRAM" button, the windows speed
show "PRO", "TIME/DISTANCE" shows "P-XX", you can choose the mode by pressing"
SPEED+" or "SPEED –" the mode is from P01 to P24. "TIME/DIST" window is on when you
press "MODE" button. The presetting time is 30:00. You can set how long you will
exercise by pressing "SPEED+" or "SPEED –".(Please press "MODE" button if you want to
come back to manual program; press "PROGRAM" button if you want to exit). Press
"START" button to start-up the manual program. They are shown 20 sections , exercising
time is setting time/20. The systems will make the noise "Bi-Bi-Bi" when it enters the
next section. The system speed will change according to the program's changing. You can
press "SPEED+" or "SPEED –" to change the speed. The system will show the speed in this
section when it enters the next section.
7 .

USER DEFINED PROGRAM

There are 3 User defined program: U-01,U-02,U-03 except 24 system manual programs
1. User's defined program:
Insert the safety key then press "START" two times into the user defined program. The
window SPEED shows "PRO"; The windows TIME/DIST shows "U-XX", you can choose the
mode by pressing" SPEED+" or "SPEED –". You can enter time setting by pressing
"MODE" button after you choose your defined program. The windows TIME/DIST shows
"30:00",you can choose your time by press "SPEED +"or "SPEED –". You can enter time
setting in every section by press" MODE" button. The window TIME/DIST shows
"U1.01",it shows that you have finished the first setting. The window SPEED shows
default speed, then you can adjust to the speed in first section by pressing "SPEED +" or
"SPEED –". After you finish the speed, then you press "MODE" button to enter the second
section, the window "TIME/DIST" shows "U1.02". All the datas will be saved until you set
again. These datas will save whether it is off or not.
8 .

PRESET PROGRAMS

It will display any of P01~P12 in the RACE TRACK LED window. You only need to preset
the time. There are 20 intervals when running and the speed will change automatically.
Refer the left-bottom charts in the panel.
9 .
RANGE OF PROGRAM
SETTING PARAMETER
TIME（MINUTE：SECOND）
SPEED
DISTANCE
HANDPULSE
（TIMES/MINUTE）
CALORIES(THERM)
SETTING
BEGIN
BEGINING VALUE
0:00 30:00
0.8 0.8
0.00 1.0
P N/A
0 50
6
SET UP RANGE DISPLAY RANGE
10:00—99:00
0.8－16.0KM/H 0.8－16.0KM/H
0.5－99.9KM/MP 0.00－99.9KM/MP
N/A
10－999
0:00－99:99
40-165
0－999