II Morrow Inc. 50 User Manual page 199

the FAF if the approach has not yet been enabled.
You will then get a message to enter the local
altimeter setting.
Enable Approach - Method 2
When an approach has been loaded, the aircraft is less
than 30 nm from the destination airport, and the
approach has not yet been enabled, pressing
result in the "Enable Approach?" prompt. If you press
while in Nav or Map mode home pages, the
SEL
prompt will also appear. Press
prompt is displayed to enable the approach. You will
then get a message to enter the local altimeter setting.
At 30 nm from Destination Airport
1. At 30 nm from the destination airport, the MSG
MSG
annunciator will flash. Press
ask if you want to "Enable approach." Press
ENTER
to enable the Approach operation. The Approach
annunciator will light and the CDI sensitivity will
automatically scale gradually from 5 nm to 1 nm
full scale.
Press ENTER to
Enable Approach
2. The display will verify that you have enabled the
selected approach. You will now be prompted to
enter the local altimeter setting. Turn the
knob to change the barometric pressure values and
turn the
ENTER
ENTER
Local Altimeter
Setting 29.92¯
3. Press
MSG
MSG
Approach Basics (GX50/60)
knob to move the cursor. Press
LARGE
.
ENTER
to return to the Navigation function.
will
FPL
when this
ENTER
. The display will
MSG
ENTER
SMALL
9-9