LifeCore Fitness LC-985VGS User's Product Manual page 6

Step 6: Upright Tube Assembly
Tools Required:
6mm Allan wrench
A. Locate hardware bags labeled (Part: #302
bolt (M8x15) & #401 washers (M8x19x1.5)
As illustrated below, lift up cover (111) and
assemble Qty. 6 bolts (302) and washers
(401) into main frame (001). If needed,
rotate the foot pedal tubes (011 & 012) for
easier access to side bolts. Using a 6mm
Allen wrench, firmly tighten the 6 Allen
bolts.
B. Slide hat cover (111) into position.
Step 7: Front Stabilizer Assembly
Tools Needed:
14mm wrench
Philips screw driver
A. Place a polystyrene block under front of
unit, now with the front of the machine
raised off the floor; use a 14mm wrench to
undo Qty. 2 bolts (308) and Qty. 2 washers
(403). Discard the red transportation tube.
B. Assemble the front stabilizer tube (002) with
the same 2 bolts (308) and 2 washers
(403), tighten bolts firm.
C. Remove the polystyrene block and discard.
D. Using a Philips screw driver, remove
preinstalled Qty. 2 screw (301) from upright
tube (004). Align water bottle holder (141)
and fasten with the same 2 screws.
Step 9: Stationary Handle Bar Assembly
Tools Needed:
6mm Allan wrench
A. Located stationary handle bar (013) and
loosen preassembled Qty bolts (302) and
Qty. 3 washers (401). Feed both the
computer cable (703) and hand pulse cable
(733) out through the top of the stationary
handle bar (013). Slide the stationary
handle bar into the upright tube (004).
B. Secure stationary handle bar with the same
Qty. 3 bolts (302) and 3 washers (401)
previously removed. Use a 6mm Allan
wrench to tighten bolts firm.
Page | 5