Assembly Instructions - LifeCore Fitness LC-985VGS User's Product Manual

Assembly Instructions

Before assembling your product, distinguish a
proper and appropriate location for the unit
where there is easy access to an electrical
outlet with a surge protector. Clear a big
enough working space before unpacking your
LC-985VG Elliptical.
Step 1: Unpackaging
A. Using a knife, gently open the carton and
cut the sides so it lays flat on the floor as
illustrated below. Unpackaged all loose
components. Double check the packing
Step 4:
materials to ensure no missing parts were
left behind.
Step 3: Rear Stabilizer Tube Assembly
Note: For SAFETY REASONS: Additional
assistance may be needed to help lift main
frame assembly.
Tools Needed:
14mm wrench
B. Remove the rear polystyrene packaging
and lift the rear of the machine off the floor.
Slide the packaging under the rear end of
the machine as illustrated below.
C. With the rear end of the machine now
raised off the floor; use a 14mm wrench to
undo Qty. 2 bolts (308) and Qty. 2 washers
(403). Discard the red transportation tube.
A. Assemble the rear stabilizer tube (003) with
the same 2 bolts (308) and 2 washers (403),
tighten bolts firm.
polystyrene packaging from under the unit.
Step 5: Upright Tube Assembly
Note: For SAFETY REASONS: Additional
assistance may be needed to help lift upright
tube onto main frame assembly.
A. Remove the front polystyrene packaging.
Note: Make sure that all wires are connected
together properly, and cover (111) is on upright
tube before positioning upright tube.
B. As illustrated below, connect computer
cable (703) to motor with cable wire (701).
Make sure wires are connected together
properly. With assistance from another
person, carefully lift the upright tube (004)
and slide the upright tube into the main
frame (001). Push and store excess wires
back into the upright tube (004). Be careful
not to pinch the wires.
Remove the rear
Page | 4