Programming; To Code A Hand-Held Remote Control; To Erase All Codes; Multi-Function Remotes - B&D Controll-A-Door 4 Instructions Manual

PROGRAMMING

Below are instructions for programming your opener
to operate with remote control transmitters.
To Code a Hand-held Remote
Control Transmitter
USING THE "SMART" BUTTON
1. Press and hold the button on the
hand-held remote * that you wish
to operate your garage door.
2. Press and release the "Smart"
button on the back panel of the
opener.
3. The light globe will blink when
the code has been accepted. If
light globe is not installed, two
clicks will be heard.
To Erase All Codes From Opener
Receiver Memory
To deactivate any unwanted remote,
first erase all codes:
Press and hold the "Smart" button on
opener until the smart indicator light
goes out (approximately 6 seconds). All previous
codes are now erased. Reprogram each remote or
keyless entry you wish to use.

*Multi-Function Remotes

If provided with your
garage door opener,
the large button is
factory programmed to
operate it. Additional
buttons on any multi-
function remote or
mini-remote can be programmed to operate other
garage door openers.
114A2558F

SPECIFICATIONS

Horsepower ....................1/2
Rated Pull Force.............800N
Type ................................Permanent split capacitor
Speed .............................1500 rpm
Volts ................................230-240 Volts AC-50Hz Only
Current............................2,0 amperes
Gears ..............................16:1 worm gear reduction
Drive ...............................Chain with one-piece trolley on
Length of Travel..............Adjustable to 2,29m (7-1/2 feet)
1 2 3
Travel Rate .....................127-178mm (5"-7") per second
9 1 9 1
7 3 7 3
5 5
KG KG
Lamp...............................On when door starts, off 4-1/2
Door Linkage ..................Adjustable door arm. Pull cord
1 2
Personal..........................Push button and automatic reversal in
Electronic ........................Independent up and down force
Electrical .........................Motor overload protector and low
Limit Device ....................Circuit actuated by limit nut.
Limit Adjustment .............Screwdriver adjustment on side panel.
Start Circuit.....................Low voltage push button circuit.
1 2 3
Length (Overall)..............3,1m (122-1/2")
Headroom Required .......5cm (2")
Hanging Weight ..............14,5 kg (32 lb)
KG KG
Operating Frequency......433.92MHz
Computer Codes ............12
Code Switch Code..........1
Keypad Code..................1
1 2 3
KG KG
31
Motor
Drive Mechanism
steel T-rail.
minutes after stop.
trolley release.
Safety
down direction. Push button and
automatic stop in up direction.
adjustment screws.
voltage push button wiring.
Dimensions
Receiver