Introduction - Allied Telesis AT-9448Ts Installation Manual

Chapter 1: Overview

Introduction

18
The switches in the AT-9400 Series are divided into the Layer 2+ group
and the Basic Layer 3 group. The switches of the two groups share many
of the same features, but there are a number of significant differences,
such as Internet Protocol version 4 packet routing and Virtual Router
Redundancy Protocol, which only the Basic Layer 3 switches support.
Three models in the Basic Layer 3 series support an additional feature
called stacking. What stacking does is it allows you to connect the
switches together so that they function as a unified Gigabit Ethernet
switch, rather than as independent units. When assembled into a stack,
the switches synchronize their actions so that network operations, like
spanning tree protocols, virtual LANs, and static port trunks, are able to
span across all of their Gigabit Ethernet ports.
The two principal advantages of stacking are:
You can configure the switches simultaneously from the same
management session, rather than individually from different sessions.
This can simplify network management.
You have more latitude in how you can configure some of the features.
For instance, when creating a static port trunk on a stand-alone switch
you have to choose ports from the same switch. In contrast, a static
trunk on a stack can have ports from different switches in the same
stack.
Before you begin to build a stack, Allied Telesis recommends reading
Chapter 1, "Overview," in the AT-S63 Stack Command Line Interface
User's Guide for background information on this feature. An
understanding of the information provided there can make the task of
installing the stack easier. Here are a few of the main points:
The switches must have Version 3.0.0 or later of the AT-S63
Management Software. Earlier versions of the management software
do not support this feature.
A stack can have up to five 48-port AT-9448Ts/XP Switches, or eight
24-port AT-9424Ts or AT-9424Ts/XP Switches or both 24-port and 48-
port switches.
The switches must have the AT-StackXG Stacking Module.