Terminal Port - Allied Telesis AT-9448Ts Installation Manual

Terminal Port

The terminal port is used to establish a local (out-of-band) management
session with the switch. You establish a local management session by
connecting a terminal or a personal computer with a terminal emulation
program to the port.
All local management sessions of a stack must be conducted through the
stack's master switch. The master switch can be determined by viewing
the Stack MSTR LEDs on the front panels of the switches. The switch
whose LED is steady green is the master switch of the stack.
The terminal port has an RJ-45 style connector. An RJ-45 to RS-232
management cable is supplied with the switch.
The terminal port is set to the following specifications:
Default baud rate: 9600 bps (Range is 9600 to 115200 bps)
Data bits: 8
Parity: None
Stop bits: 1
Flow control: None
Note
These settings are for a DEC VT100 or ANSI terminal, or an
equivalent terminal emulation program.
AT-9400 Stack Installation Guide
33