Installing An Xfp Transceiver - Allied Telesis AT-9448Ts Installation Manual

Chapter 4: Cabling the Network Ports
Installing an XFP
Transceiver
78
To install an XFP transceiver in the AT-9424Ts/XP or AT-9448Ts/XP
Switch, perform the following procedure:
1. Remove the dust plug from a transceiver slot on the switch. Refer to
Figure 34.
Figure 34. Removing an XFP Dust Plug
2. Remove the transceiver from its shipping container and store the
packaging material in a safe location.
3. Position the transceiver with the label facing down.
4. Slide the transceiver into the slot until it clicks into place, as shown in
Figure 35.
Figure 35. Installing an XFP Transceiver