At-Rps3204 Redundant Power Supply - Allied Telesis AT-9448Ts Installation Manual

At-9400 series gigabit ethernet switches

Hide thumbs Also See for AT-9448Ts:

Table of Contents

Chapter 1: Overview

AT-RPS3204 Redundant Power Supply

The RPS connector on the back panel of the switch connects to the

optional AT-RPS3204 redundant power supply unit, shown in Figure 8.

The unit can provide power to the switch in the event that the switch's

internal power supply fails.

The AT-RPS3204 redundant external power supply features one

preinstalled AT-PWR3202 Power Module and three empty slots for

additional power modules. Each power module can support one switch.

When fully populated with AT-PWR3202 Power Modules, the

AT-RPS3204 unit can support up to four switches simultaneously. For

information about installing an AT-RPS3204 unit, consult the

documentation shipped with the unit.

P O W

E R

AT-RPS3204 Redundant Power Supply Unit

Figure 8

The pinouts for the redundant power supply's 21-pin D-combo port and

connector are described in "RPS 21-pin D-combo Port and Connector

Pinouts" on page 98.

Table of Contents

At-9424ts At-9448ts/xp At-9424ts/xp T-9424ts