Tie-To-Co Transfer - Panasonic KX-TD816CE Installation Manual

438
Description
Selection
Default
Programming
Conditions
50
System Programming

TIE-to-CO Transfer

Enables or disables transferring TIE calls to a CO line on a CO line
group basis. This restriction applies to the following: 1) An outside
call through another PBX 2) Call Forwarding to a CO line 3) Call
Transfer to a CO line.
• CO line group (TRG) number: 1 through 8,
• Enable / Disable
All CO line groups – Disable
1. Enter 438.
Display : TIE-CO Transfer
2. Press NEXT.
Display: TRK GRP NO?→
3. Enter a CO line group number.
To enter CO line group number 1, you can also press NEXT.
Display example: TRG1:Disable
4. Keep pressing SELECT until the desired selection is
displayed.
5. Press STORE.
6. To program another CO line group, press NEXT or PREV, or
SELECT and the desired CO line group number.
7. Repeat steps 4 through 6.
8. Press END.
To assign all CO line groups to the same selection, press the
step 3. In this case, the display shows the contents programmed for CO
line group number 1.
( =all CO line groups)
key in