Two-Way Transfer Button Assignment Via Station Programming - Panasonic KX-TVS80 Installation Manual

INTEGRATING THE VPS WITH THE PANASONIC KX-TA SERIES PBX AND KX-TD SERIES PBX
Conditions:
4.5.10 Two-Way Transfer Button Assignment via Station
Programming
For the Two-Way Transfer feature to work at an extension, the extension must have a TWT
button on it. This key must either be a DSS/BLF or CO key with a lamp. Follow the procedure
below to assign a TWT button on an extension. (This is a station level program and should be
done at each individual telephone.)
PC programming is also available for KX-TD500 users (see 4.5.12 Button Assignment via
PC Programming).
1.
Enter PITS Programming:
For KX-TA624
With the phone on-hook, Set the MEMORY switch to "PROGRAM".
(Display changes to PITS-PGM Mode.)
For KX-T series PBX that uses DPT Integration
a. With the phone on-hook, Press the PROGRAM button.
b. Dial [99]. (Display changes to PITS-PGM Mode.)
2.
Press the desired FLEXIBLE (CO or DSS/BLF) button that you want to assign as the
TWT button.
3.
Dial [91].
Screen output: 2Way-Trans:
4.
Dial the Voice Mail extension number.
Screen output: 2Way-Trans: _ _ _
(_ _ _ = The extension number you entered).
5.
Press STORE.
6.
For KX-TA624
Set the MEMORY switch to "SET".
For KX-T series PBX that uses DPT Integration
Press the PROGRAM button or lift the handset.
7.
Repeat these steps for each telephone.
Conditions:
Installation Manual
All manuals and user guides at all-guides.com
This button must be a CO or DSS/BLF key to be
programmed as a TWR button. If this key is pressed
when all Voice Mail ports are busy, the user will hear a
reorder tone.
This button must be a CO or DSS/BLF key to be
programmed as a TWT button. When all Voice Mail
ports are busy and this key is pressed, the user will hear
reorder tone.
111