Co-To-Tie Transfer - Panasonic KX-TD816CE Installation Manual

System Programming
Description
Selection
Default
Programming
Conditions

CO-to-TIE Transfer

Enables or disables transferring an incoming outside call to the TIE
line on a CO line group basis. This restriction applies to the
following: 1) A TIE call using DISA 2) Call Forwarding to a TIE
line 3) Call Transfer to a TIE line.
• CO line group (TRG) number: 1 through 8,
• Enable / Disable
All CO line groups – Disable
1. Enter 437.
Display : CO-TIE Transfer
2. Press NEXT.
Display: TRK GRP NO?→
3. Enter a CO line group number.
To enter CO line group number 1, you can also press NEXT.
Display example: TRG1:Disable
4. Keep pressing SELECT until the desired selection is
displayed.
5. Press STORE.
6. To program another CO line group, press NEXT or PREV, or
SELECT and the desired CO line group number.
7. Repeat steps 4 through 6.
8. Press END.
To assign all CO line groups to the same selection, press the
step 3. In this case, the display shows the contents programmed for CO
line group number 1.
( =all CO line groups)
437
key in
49