Panasonic KX-TD816CE Installation Manual page 70

109
Conditions
70
4.3 System Programming
Expansion Unit Type
3. Keep pressing SELECT until the desired selection of Area 1
is displayed.
4. Press to program another Area, if required.
5. Keep pressing SELECT until the desired selection of the
Area is displayed.
6. Repeat steps 4 and 5 until all of the required entries are
completed, if required.
7. Press STORE.
If only one system is in operation, go to step 10.
8. Press NEXT to program the Slave System.
Display example: Slave :C ;E1;E2
9. Repeat steps 3 through 7, if required.
10. Press END.
• Each parameter corresponds to an expansion unit as follows:
C=KX-TD180, S1=KX-TD280, S2=KX-TD286, E, E1 and
E2=KX-TD170, A, A1 and A2=KX-TD174, EM=KX-TD184
• There are two expansion areas in the KX-TD816, areas 1 and 2 from
bottom to top. Either one 8-Station Line Unit or 16-SLT Line Unit and
either one 4-CO Line Unit, 4-E&M Line Unit, 2-ISDN S0 Line Unit or
6-ISDN S0 Line Unit can be installed.
• There are three expansion areas in each system for the KX-TD1232,
areas 1, 2 and 3 from bottom to top. Either up to two 8-Station Line
Units or 16-SLT Line Units and either one 4-CO Line Unit, 4-E&M
Line Unit, 2-ISDN S0 Line Unit or 6-ISDN S0 Line Unit can be
installed in each system.
• An out-of-service system is unassignable. In this case, skip steps 8 and
9 for the KX-TD1232.
• For the KX-TD1232, if only the Slave System is in operation, the
display shows "Slave" in step 2.
• After changing the setting, turn the Power Switch off and on once.
Otherwise, the previous setting will remain.