System Programming
Description
Selection
Default
Programming
Conditions
TIE-to-TIE Transfer
Enables or disables transferring TIE calls to a TIE line on a CO line
group basis. This restriction applies to the following: 1) A TIE call
through another PBX 2) Call Forwarding to a TIE line 3) Call
Transfer to a TIE line.
• CO line group (TRG) number: 1 through 8,
• Enable / Disable
All CO line groups – Enable
1.
Enter 439.
Display : TIE-TIE Transfer
2.
Press NEXT.
Display: TRK GRP NO?→
3.
Enter a CO line group number.
To enter CO line group number 1, you can also press NEXT.
Display example: TRG1:Enable
4.
Keep pressing SELECT until the desired selection is
displayed.
5.
Press STORE.
6.
To program another CO line group, press NEXT or PREV, or
SELECT and the desired CO line group number.
7.
Repeat steps 4 through 6.
8.
Press END.
To assign all CO line groups to the same selection, press the
step 3. In this case, the display shows the contents programmed for CO
line group number 1.
( =all CO line groups)
439
key in
51