Ogm Mode Selection - Panasonic KX-TA308 Installation Manual

4.2 System Programming

[502] OGM Mode Selection

Selects how the 2 outgoing messages (OGM1 and OGM2) are used, MODE1 through
MODE5.
Mode
1
2
3
4
5
5
Default
• Programs [414]-[416] "Outside (CO) Line Mode – Day/Night/Lunch" are used to assign
!
!
"DISA1", "DISA2" or "UCD" to each outside (CO) line according to this assignment.
UCD-END is used automatically when UCD is assigned in programs [414]-[416],
"Disconnect" is selected in program [523] "UCD Busy Mode", and "MODE4" is selected
in this program.
• If the optional OGM/FAX Detection card is not installed, this assignment should be
"MODE1".
• Feature References
Section 3, Features
Direct Inward System Access (DISA), Outgoing Message (OGM),
Uniform Call Distribution (UCD)
OGM1 OGM2
DISA1 DISA1 The system can receive 2 incoming calls via the DISA feature
at the same time. This is useful when receiving many calls.
DISA1 DISA2 An example: DISA1 is used in the day mode and DISA2 is
used in the night mode.
UCD UCD The system can hold up to 2 incoming calls via the UCD
feature at the same time until any extension is available.
UCD UCD- The system disconnects an incoming call via the UCD feature
END when the assigned waiting time in [521] "UCD Busy Waiting
Time" expires.
UCD DISA1 An example: UCD is used in the day mode and DISA1 is used
in the night mode.
0
2
NEXT
MODE1
SELECT
STORE
(MODE 1/
2/3/4/5)
Description
END
System Programming
[502]
4-57