Panasonic KX-TA308 Installation Manual page 71

3 Features
*9: If the destination extension belongs to a hunting group and all extensions in the group are busy,
the system will check the DISA Busy Mode. If the destination is a DISA ring group, the DISA
Busy Mode will not work for the call. The system regards the call as unanswered.
*10: The DISA Busy Mode is selected in program [506]. There are 3 modes as follows.
• Disconnect –
• Call Waiting – the destination extension hears a call waiting tone if they have enabled Call
• DISA2 –
*11: The DISA Ring Timer Before Intercept starts. The destination telephone(s) will ring for the
time programmed in [508].
*12: In this case, the system disregards the security type and does not accept a line access code. If
nothing is recorded in OGM2 or OGM2 is used for another caller, the caller will hear a busy
tone and the call is disconnected.
*13: The OGM is sent to the caller according to programs [414]–[416] and [502] when the
assigned time in program [519] expires. If an OGM is not recorded, the DISA Wait Timer
After OGM programmed in [505] starts immediately.
When the system detects a FAX (CNG) tone while the OGM is being sent, the call is sent to
the FAX extension assigned in program [503]. When the system detects a cyclic tone or CPC
signal while the OGM is being sent, the call is disconnected.
*14: The DISA Wait Timer After OGM starts. The system waits for a number from the caller
during the time assigned in program [505]. When the system detects a FAX (CNG) tone
during the programmed time, the call is sent to the FAX extension. When the system detects a
cyclic tone or CPC signal during the programmed time, the call is disconnected.
*15: After the DISA Wait Timer After OGM or the Intercept Timer for Internal DISA expires, the
system regards that nothing was dialed.
*16: The system treats the call according to program [510] as follows.
• Disconnect – the call is disconnected.
• Intercept –
*17: The DISA Ring Timer After Intercept starts. The destination telephone(s) will ring for the
time programmed in [509]. If the call is not answered during the programmed time, the call
will be disconnected.
*18: The FAX extension assigned in program [503] receives the call. When the extension is busy,
the system sends a busy tone to the sending FAX. If the call is not answered after 40 seconds,
the call will be disconnected.
Program [514] sets how many times the FAX (CNG) tone must be detected before the system
recognizes the incoming signal as facsimile data.
the caller hears a busy tone and a call is disconnected.
Waiting.
if "MODE2" is assigned in program [502] and a message is recorded in
OGM2, the caller will hear the message and the system waits for the new
destination.
the call is sent to the extensions programmed in [408]-[410]. If all
extensions are assigned to "Disable", the call will be disconnected.
D
3-21
Features