Ogm Mode Selection - Panasonic KX-TA624 Installation Manual

4.2 System Programming

[502] OGM Mode Selection

Selects how the 2 outgoing messages (OGM1 and OGM2) are used, MODE1 through
MODE6.
Mode
1
2
3
4
5
6
5 0
Default
!
• Programs [414]-[416] "Exchange Line Mode – Day/Night/Lunch" are used to assign
!
"DISA1", "DISA2" or "UCD" to each exchange line according to this assignment.
• UCD-END is automatically used when "UCD" is assigned in programs [414]-[416],
"Disconnect" is selected in program [523] "UCD Busy Mode", and "MODE4" is selected
in this program.
• DISA is automatically used when "UCD" is assigned in programs [414]-[416], "Intercept"
is selected in program [523], and "MODE6" is selected in this program.
• If the optional OGM/FAX Detection card is not installed, this assignment should be
"MODE1".
• Feature References
Section 3, Features
Direct Inward System Access (DISA), Outgoing Message (OGM),
Uniform Call Distribution (UCD)
OGM1 OGM2
DISA1 DISA1 The system can receive 2 incoming calls via the DISA feature
at the same time. This is useful when receiving many calls.
DISA1 DISA2 An example: DISA1 is used in the day mode and DISA2 is
used in the night mode.
UCD UCD The system can hold up to 2 incoming calls via the UCD
feature at the same time until any extension is available.
UCD UCD- The system disconnects an incoming call via the UCD feature
END when the assigned waiting time in [521] "UCD Busy Waiting
Time" expires.
UCD DISA1 An example: UCD is used in the day mode and DISA1 is used
in the night mode.
UCD DISA The system leads an incoming call via the UCD feature to the
DISA feature by OGM2 when the assigned waiting time in
[521] "UCD Busy Waiting Time" expires and "Intercept" is
selected in [523] "UCD Busy Mode".
2
NEXT
SELECT
(MODE 1/
2/3/4/5/6)
MODE1
Description
STORE END
System Programming
[502]
4-59