Receiving; Transmitting - RTS DV-3400 Instruction Manual

BASIC OPERATIONS
need to press
displayed on the LCD twinkles, secondly, press
to up or down the channel number, and then the
transceiver will announce the adjusted channel number. Press
to upward the channel number and
number. Press any key except
entering the setting mode, if users do not set the frequency or not
exit the mode after adjusting the channel number, the transceiver
will exit the setting mode automatically after 10seconds.
NOTE: When adjusting channel, the transceiver will
automatically skip blank channels which are not edited.
Suppose you want to adjust the channel from NO.1 to NO.2, if
channel NO.2 is blank, the transceiver will skip it and jump to
channel NO.3.

Receiving

Once current channel is called, backlight lightens all the time, and
then you can hear other party calling.
NOTE:
•You may not receive the calling if you set a high squelch off
level of the transceiver.
•If current channel has been programmed with signaling, you
can only hear the call from a same signaling, other calls can't
be heard.

Transmitting

Be sure that the channel you want to use is not in
busy state through monitoring for a while by pressing
the programmed Squelch off [PF1] / [PF2] key. Under
these conditions, press the [PTT] key and speak
15
repeatedly untill the channel number
or
to downward the channel
, to confirm and exit. After