Fast Adjust Frequency; Channel Selection - RTS DV-3400 Instruction Manual

BASIC OPERATIONS
dot on the LCD twinkles. Under this state, press
desired current frequency. Press
value by step,
Press [PF1] or [PF2] key to confirm the selected
frequency and exit the frequency setting mode. After
entering the setting mode, if users do not set the
frequency or not exit the mode after adjusting the
frequency, the transceiver will exit the setting mode automatically
after 10seconds.
NOTE:
Under channel mode, this function would be hidden. VFO
function is disabled as factory default. You can enable this
function via programming software.

Fast Adjust Frequency

Under VFO( frequency mode), press
decimal dot on the LCD twinkles. Under this state, press
to set desired current frequency. Press
frequency value by 1MHZ,
1MHZ.Press [PF1] or [PF2] key to confirm the selected frequency
and exit the frequency setting mode. After entering the setting
mode, if users do not set the frequency or not exit the
mode after adjusting the frequency, the transceiver will
exit the setting mode automatically after 10seconds.
NOTE:
Under channel mode, this function would be hidden.This
function is disabled as factory default. You can enable this
function via programming software.

Channel Selection

Under channel mode, to choose the desired channel, firstly, users
to decrease the frequency value.
to decrease the frequency value by
/
to increase the frequency
repeatedly untill the
to increase the
to set
/
14