Optional Fan Kit Installation - kozy heat DULUTH 55801 Installation And Operation Manual

OPTIONAL FAN KIT INSTALLATION

INSTALLATION OF THIS FAN SHOULD BE DONE ONLY BY A QUALIFIED INSTALLER
This optional #DUL-028 fan kit includes:
- Right & left fan assemblies - mounted
- (4) Flange nuts
- Temperature control switch with magnet attached
WARNING: MAKE SURE HOUSEHOLD BREAKER IS SHUT OFF PRIOR TO WORKING ON ANY ELECTRICAL LINES.
WARNING: This appliance is equipped with a three-prong (grounding) plug for protection against shock hazard and should be plugged into
a properly grounded three-prong receptacle. Do not cut or remove grounding prong from plug.
NOTE: This appliance must be electrically grounded and connected in accordance with local codes, or in the absence of local codes, with the National
Electrical Code, ANSI/NFPA 70 Current Edition, or the Canadian electrical Code CSA C22.1.
NOTE: This fan will not operate unless speed control has been turned ON and sufficient heat has been applied to temperature control switch. The fan
will turn ON and OFF automatically as fireplace heats and cools. Adjust fan to desired speed while it is running.
NOTE: We recommend that an electrical outlet be installed near fireplace.
1. Attach fan shield to fan assembly by aligning holes in shield to holes in fans assembly.
Secure with hex head screws.
2. Locate (4) mounting studs underneath rear of fireplace.
3. Slide fan underneath fireplace, lift up, making sure flange on shield wraps around
ledge on back of stove, align (4) mounting holes / slots in fan bracket to mounting
studs under firebox. Secure with (4) nuts (included).
4. Mount speed control box onto left side of gas valve bracket by aligning slots in box to
holes in bracket. Secure with (2) black phillips head screws, included.
5. Place temperature control switch (magnet attached) onto bottom of firebox as close to
center as possible.
6. Plug fan cord into receptacle on speed control box.
7. Plug speed control box cord into a properly grounded three-prong receptacle.
8. Turn speed control counter-clockwise until it „clicks‟. This is the OFF position.
9. Turn speed control ON by turning knob clockwise past „click‟ - this is the highest
setting.
TEMPERATURE CONTROL SWITCH POSITION
Before adjusting temperature control switch, unplug 3-prong plug on fan cord from receptacle.
Adjust position of temperature control switch to a warmer location under firebox to turn fan „ON‟
sooner or move it to a cooler location under firebox to turn fan „ON‟ later. The fan will turn on when
sensor in temperature control switch reaches 110° F and will turn „OFF‟ when sensor reaches 90° F.
After adjustment, plug 3-prong plug on fan cord into receptacle.
Figure 10b
- Fan cover plate
- (3) Hex Head Screws
- Speed Control Box with 8 ft. cord
Ground
Temperature Control Switch
PAGE 10
- Fan Shield
- (2) Phillips head screws (black)
Figure 10a