Series Nms - Paradyne WIRELESS DATA GATEWAY Installation And Operation Manual

Wireless Data Gateway
Configuration
Group
Misc, continued NetMngmtAddress
NMS_Call_Msgs
NMS DTR Alarm
CellulrRJ11Adpt
Audio Timeout
Security NMS_Reporting
Answer_Secur
Originate_Secur
*WDG modems should be part of the NMS addressing plan. NetMngmtAddress must be set for each modem.
Modem Repair and Maintenance
When a modem is removed from the carrier, a switch is
activated in the 4-Wire E&M NIM which puts the M-lead
in the off-hook, or active state. This removes the port
from service.
In addition, when a modem is removed from a slot, its
partner modem detects this on its DTE crossover cable.
This causes the partner modem to set its M-lead to the
active state, taking it out of service as well.
It is not necessary to power down the carrier to remove
and replace a 3811Plus modem. Perform the following
steps.
Procedure
CAUTION
If you remove the 3811 Plus
modem from the carrier,
always use a ground strap
when handling the modem.
Always store the 3811 Plus in
an antistatic bag when it is
removed from the carrier.
1. Rotate the circuit pack lock until the release tab is
exposed.
2. Press down on the release tab and pull the modem
away from the carrier's backplane.
4-10
Table 4-1
3811 Plus Modem Configuration (3 of 3)
Configuration Option
November 1996
Value
001*
CallCnct&Prg
Disable
Disable
000 sec
00
No_Answ_Sec
No_OrigSec

6700 Series NMS

There are no installation or configuration requirements
for the 6700 Series NMS that are specific to the WDG.
Install the 6700 Series NMS and add the modems in the
WDG to your network configuration as shown in the
COMSPHERE 6700 Series Network Management System
User's Guide.
AT Command
S75=0
S66=0
S77=0
S93=0
—
—
—
—
3981-A2-GN31-20