The Handy THS125 Operator's Manual And Parts List page 10

STEP 3: Installing the Hopper
1. Lower the hopper over the mounting assembly, carefully line up the holes in the bottom of the
hopper with the spindle in the mounting plate of the axle.
2. Use the M6 x 40 hex bolt and Ø6 flat washer to attach the hopper to the mounting assembly and
secure with M6 lock nut.
3. Make sure the gear and pinion gear works smoothly. If not, adjust again until the gear and pinion
gear swivel smoothly.
4. Tighten all the hardware on the shaft support plate and hopper.
5. Insert the R Pin through the top of the spindle.
- 10 -