Advertisement
STEP 2: Assembling the Support Leg
1. Position the support leg so the J-shaped end is pointing away from the wheel assembly.
2. Insert the M8x75 hex bolt through the top hole on the support leg and slide the spacer over the bolt
end.
3. Take the support leg and insert the bolt through the upper cross bar on the mounting assembly
and loosely tighten with the M8 lock nut.
NOTE: Before tightening the bolt make sure the support leg flange and the lower cross bar holes
line up.
4. Insert M6 x 40 hex bolt through the holes in the flange and cross bar. Use the Ø6 big flat washer
and M6 lock nut.
- 9 -
Cross Bar
Flange
Advertisement
