Installation - Harman Accentra Pellet Insert Installation & Operating Manual

H t e uce t e
1. Remove the top lid assembly and side panels.
te em a t e ca t
necessary or recommended.
Note: The hopper lid must be in the OPEN position before
the top lid assembly can be lifted off or reinstalled on the
stove body.
There are ( ) 1 -20 x 1 2 flange head bolts securing the
top lid assembly to the stove body. They can be removed
from the underside with a
The cast top and lid assembly bolt down bars:
On each side of the stove body, underneath the cast top,
are (2) 1 flange head bolts. See ig. 12.
These bolts pull the cast top and lid assembly down onto the
hopper gasket to seal the hopper.
They also allow for a small amount of front to back ad ustment
for alignment of the top into the wing pockets.
Protector Angles: These angles are designed to
protect the blower motor from damage when placed
on a flat surface. Be careful where and how the stove
ig. 10
body is handled.
ounting Shell

Installation

e t r n ta at n
pper t e
8 socket.
B e c a r e f u l n o t
t o d a m a g e t h e
distribution blower
located under the
insert. There are
guards on both sides
of the motor to allow
the insert to rest on a
flat surface, however,
extra care should be
taken.
istribution Blower
(2) Spring Latches
(One on each side)
ig. 11
NOT
ig. 12
NOTICE: When removing the top and lid assembly,
first remove the hopper lid position switch from its
mounting bracket. Loosen the switch retainer nut,
and allow the switch to drop out of the bracket. ea e
the bracket in place.
Top and Lid Assembly
Ash Pan
Bolts req uire a
3 / 8 " socket.
(V iew looking up under the cast top.)
Top bolt down bar
Center
edallion
Exchanger
lame Guide
3 -9 0 -0 0 6 7 4 R 2 7 _ 8 /1 3
Heat
Cover
Internal
Cast Iron
(4 ) pieces