Harman Accentra Pellet Insert Installation & Operating Manual page 23

The chimney top must be capped
to prevent rain and or snow from
entering the chimney.
See Page 22. for information on
the optional Harman Ad ustable
Stainless Steel Intake Extension.
The damper area must be
sealed with a steel plate and it
is recommended that
ineral wool or an equivalent
non
is used on top of the plate
to reduce the possibility of
condensation. Insulation alone
should not be used to seal the
damper opening.
ig.
The chimney top must be capped
to prevent rain and or snow from
entering the chimney.
The damper area may be
sealed with a steel plate. If
so, it is recommended that
aowool,
equivalent
insulation is used on top of the
plate to reduce the possibility of
condensation. Insulation alone
should not be used to seal the
damper opening.
ig. 50
V enting
aowool,
combustible insulation
Height of existing
hearth
ineral wool or an
non combustible
1 n ta n nt an e
This method provides excellent venting with 100
which is the most efficient operation of this unit. This method
also provides natural draft in the event of a power failure.
A inch stainless steel flex pipe is needed for the flue pipe,
and aluminum or Stainless Steel lex Pipe is used for
the intake.
W AR NING
CHIMNEY CONNECTOR
THR OUG H CONCEALED SPACES INCLUDING
ATTIC, R OOF SPACE, CLOSET, F LOOR OR CEILING .
2 n ta n nt an e
This method provides excellent venting for normal operation.
This method also provides natural draft in the event of a
power failure.
A cap should be installed on the chimney to keep out rain.
Combustion air is provided from the living area and enters the
feed system from around the wing and stove body spaces.
2 3
t n firep ace c mney
outside air
PIPE MAY NOT PASS
AN
t n firep ace c mney
3 -9 0 -0 0 6 7 4 R 2 7 _ 8 /1 3