Harman Accentra Pellet Insert Installation & Operating Manual page 18

ay c nnect t e p
pu e r m t e m unt n
As you can see, the control board is easily accessible from
the rear with the body pulled out of the frame, even if it is
only pulled out several inches.
• Always inspect the wiring harness of the 11 pin socket
(large white flat plug where all of the power wires
terminate.)
• Always inspect the wiring harness where the wires transfer
from the control to the rear inside of the body.
• ake sure there are no worn or frayed areas.
Inspect the wiring harness transition area: This is the area
that comes closest to the mounting frame as the unit is slid
in and out of the frame.
ig. 0
R EMINDER S
• Do not allow pellets or sawdust to build up on the
hopper lip.
• n pect t e pper
pper ea ery mp rtant
Installation
W iring
er c r e re t e un t
rame
6 amp
glass
u e
1 1 pin
socket
on rear
board
a ket r ama e
r pr per perat n
Hopper lid foam
gaskets
Cast Top
ig. 2
Install the log bracket with the two thumb screws provided.
c ntr
Center the log in the firebox opening with the bottom front
edge over the thumb screws. The log branch tips only rest
on the bracket arms for easy installation and removal.
IMPOR TANT NOTE: BEF OR E CLEANING
EX CHANG ER S, THE LOG
MUST BE R EMOV ED.
ig. 1
Log Set Option
Thumb
Screws
F ig. 4 3
AND THE LOG
3 -9 0 -0 0 6 7 4 R 2 7 _ 8 /1 3
1 8
THE HEAT
BR ACK ET