Harman Accentra Pellet Insert Installation & Operating Manual page 15

1 5 . Install the cast side panels by sliding them down over
the lasered hinge pin. Note: Check for rotational swing,
but finish with them in the open position. The cast side
panels may need ad ustment after the stove body is
latched into place and the front door is closed.
ig. 0
Lasered hinge pin
pivoting point
Up and down clearance
ad ustment slots.
1 6 . Place the stove body on the mounting shell gasketed rails
and insert the body into the opening far enough that it
can t tip out. Note: A service rail kit (Part #1-00-08007),
or a pair of 2 x s supported in front of the hearth will
make this ob easier. See ig. 1.
1 7 . Complete the following electrical connections (CAUTION:
isconnect the power cord.) There are 5 connections
that must be completed. See ig.
ig. 1
Installation
Cast side panel
hinge
.
2 x
nnect n t e r un
t e y
The green wire with a female terminal is the stove body
ground. See ig. 2
On the combustion air inlet box there is a male terminal
ground.
er ce per rme
c nnect n mu t e t e fir t ne n an t e a t ne
Connecting the power cord
The white from the mounting frame connects to the white of
the insert body. The black from the mounting frame connects
to the brown of the insert body.
ig.
r m t e n t t e
n t t e t r un
ig. 2
3 -9 0 -0 0 6 7 4 R 2 7 _ 8 /1 3
1 5