Wall-Hung Model; Fitting The Scan 58 Wall-Hung Model - SCAN 58 - series Assembly And Instruction Manual

Fit the cast iron cooking plate in the smoke outlet. Place the top plate
on the stove.
D
Allen screw
A S S E M B LY
Screws for adju-
sting the height
of the frame for
the top plate
Screws for
adjusting
the height
D
of the top
plate
Bracket

Wall-hung model

Installation must be planned and executed in accordance with natio-
nal and local building regulations.
The stove must only be fitted to a non-flammable wall. There must
be no form of flammable component in the wall. In the case of thin
walls, nor must there be any behind the wall. The load-bearing capa-
city of the wall must be checked under all circumstances.
To ensure correct installation we recommend that a building expert
be commissioned to plan and outline the installation with a view to
subsequent approval.
For wall installation we recommend using the wall brackets supplied.
If a chimney is installed on top of a wall-hung model, the chimney
must be fully self-supporting. It must not rest on the wood-burning
stove. There must be a distance of at least 6 mm between the first
section and the flange on the flue collar (see below). Please consult
a specialist.
Scan A/S disclaims all liability for the installation of wall-hung
wood-burning stoves.

Fitting the Scan 58 wall-hung model

Remove the screws in the rear casing of the stove.
Remove the type plate from the stove and replace it with the type
plate corresponding to the wall model in question. The type plate for
the wall model is packed together with the wall fitting.
17
First section
Flange on
the con-
necting
piece