Mounting Of High Top For Scan 58-7 And Scan - SCAN 58 - series Assembly And Instruction Manual

Mounting of high top for Scan 58-7 and Scan 58-8

If you choose to connect the stove with an elbow pipe or a rear out-
let, the stove must be mounted to the wall behind the oven using a
special wall mounting kit. This kit can be purchased from your local
Scan dealer. For fitting, see page 24.
It is very important that the base is level and stable.
The type plate delivered with the high top is to replace the type plate
placed on the stove. Remove the existing type plate from the stove
and replace it with the new one. The type plate is to be found in the
compartment under the burn chamber.
Mounting of the high top:
The front plate of the high top is removed as follows:
Loosen the screws (pos. J). Remove the Allen screws (pos. K). Remove
the front of the high top.
K
K
2 x allen screws M5x25
J
Loosen the screws in the bottom
of the high top.
A C C E S S O R I E S
Remove the top plate and the frame for the top plate. The Allen
screws and discs (pos. L) are to be reused when the high top is faste-
ned on the stove.
When remounting the frame for the top plate, it should be turned
180°, so that the heat shield turns towards the front of the door of
the stove.
Heat shield
J
L
4 x allen screws M6x10
4 discs Ø 6.5 / Ø16 x 1.1
21
L