Troubleshooting - SCAN 58 - series Assembly And Instruction Manual

Smoke escaping
• Damp wood
• Chimney not drawing properly
• Chimney is not properly dimensioned for the stove
• Check if the smoke gas pipe/chimney are blocked
• Is the chimney the right height for its surroundings?
• At rear outlet, check that the flue pipe does not obstruct the
chimney draught
• Vacuum in room
• The door is opened before the embers have burned down
sufficiently
Wood burning too quickly
• The air valves are set incorrectly
• The baffle plates is incorrectly mounted or missing
• Inferior firewood (waste wood, pallets etc.)
• Chimney too large
Soot build-up on glass
• Incorrect secondary airflow setting
• Excessive primary air
• Damp wood
• Wood pieces too large on lighting
• Inferior firewood (waste wood, pallets etc.)
• Chimney not drawing sufficiently
• Vacuum in room
Excessive soot build-up in chimney
• Poor burning (more air required)
• Damp wood
The surface of the stove is turning grey
• Overheating (see instructions for heating)
Poor heating performance of stove
• Damp wood
• Not enough wood
• Inferior wood quality with low fuel value
• Baffle plates are not fitted correctly
Odour coming from stove
• The lacquer on the stove hardens when you use the stove for the
first time; this can cause an odour. Open a window or a door for
ventilation, and make sure the stove is heated up sufficiently to
avoid odours later.
• When heating up and cooling down, the stove may make some
clicking noises. These are due to the huge temperature diffe-
rences to which the material is exposed and do not indicate any
product defects.
T R O U B L E S H O O T I N G
Warranty
All wood-fired Scan products are made of high-quality materials and
subject to strict quality controls before leaving the factory. We give a
warranty of 5 years on manufacturing errors or defects.
You must quote your stove's product registration number when you
contact us or your authorised Scan dealer with a warranty claim.
The warranty covers all parts which in the opinion of Scan A/S require
repair or replacement due to manufacturing or construction error
The warranty applies to the original purchaser of the product only,
and is not transferable (except on prior sale).
The warranty covers only damage caused by manufacturing or con-
struction errors.
The following parts are not covered by the war-
ranty
• Wear and tear parts, such as the combustion chamber liners,
• Defects caused by external chemical and physical influences
• Soot build-up caused by poor chimney draught, damp wood, or
• Costs of additional heating in connection with a repair.
• Transport costs.
• Costs for setting up, removing the wood stove.
This warranty is void
• In case of incorrect installation (the installer is responsible for
• In case of improper use, and/or use of prohibited fuels, non-
• If the product registration number of the stove has been remo-
• In case of repairs that do not comply with our instructions or
• In case of any manipulation of the original state of this Scan
• This warranty is only valid in the country to which this Scan
Always use original replacement parts, or parts recommended by the
manufacturer.
baffle plates, riddling grate, glass, tiles, and seals (except for
defects which were present on delivery).
during transportation, storage and assembly, or at a later time.
improper use.
observing and complying with legal requirements and local
bylaws, along with this Assembly- and Instructionsmanual for
the wood-burning stove and accessories).
original spares (see this Assembly- and instructions manual).
ved or damaged.
instructions by an authorised Scan dealer.
product or its accessories.
product was originally supplied.
35