Programmable Sensor Keys - Siemens HiPath 500 Operating Instructions Manual

Programmable sensor keys

Your OpenStage 60/80 T has eight illuminated sensor keys to which you
can assign functions or numbers.
Increase the number of programmable sensor keys by connecting a
key module
Depending on how they are programmed, you can use the sensor keys as:
• Function keys
• Repdial keys
• Procedure keys
You can program internal and external station numbers on the sec-
ond level for all programmable sensor keys (except the Shift key).
The LED function is not available for internal station numbers on
the second level.
Touch the key to activate the programmed function or dial the stored num-
ber.
Press and hold a function key or repdial key to open a menu for program-
ming it. Direct station selection (DSS) keys can only be programmed via
the service menu.
A label indicating the key's function is displayed to the left of the key; it can-
not be changed. You can change the labels for repdial or DSS keys accord-
ing to your requirements
The status of a function is shown by the LED on the corresponding sensor
key.
Meaning of LED displays on function keys
LED Meaning of function key
S
Off The function is deactivated.
T
[1]
Flashing The function is in use.
R
On The function is activated.
[1] In this manual, flashing sensor keys are identified by this icon, regardless of the flashing
interval. The flashing interval represents different statuses, which are described in detail in
the corresponding sections of the manual.
The programmable sensor keys on multi-line phones function as
trunk keys
Getting to know your OpenStage phone
page 15.
page 79
page 84
page 82
page 86.
page 123.
19