Operating The Balance; Balance Display - Sartorius MC 210 S Installation And Operating Instructions Manual

Operating the Balance

Balance Display

The display shows the following special codes
for your information:
OFF
The balance was disconnected from AC power
(power failure or outage; the balance was reconnected
to AC power).
O (standby)
The display has been turned off by the e key (31).
The balance is now in the ready-to-operate mode.
b (busy)
Once you have turned on the balance, the b symbol
will be displayed until you press a key.
During operation, this symbol indicates that the
balance processor is still busy processing a function
and will not accept commands to perform any other
functions at this time.
CAL I
The balance has internal calibration weights and
can be calibrated using the f key.
R1 W or R2 W
The number in the R code identifies the particular
weighing range you have selected.
W
Symbol for the application selected (in this case,
the weighing mode and toggling among the
weighing ranges).
Important Note:
If the W symbol flashes, this means that the balance
wants to self-calibrate (see pp. 1–30).
1–19