Balance/Scale Operating Menu; Accessing The Balance/Scale Operating Menu And Changing Menu Code Settings - Sartorius Portable Series Service Manual

Balance/Scale Operating Menu

In the balance/scale operating menu, you can change individual code settings regarding the weight unit, balance/
scale response, display response, data output parameters and application parameters.
For the factory-set menu codes, please refer to „Overview of the MP 10.3 Menu" (see page 11).

Accessing the Balance/Scale Operating Menu and Changing Menu Code Settings

Please proceed as follows to access the balance/scale operating menu:
If you would like to check or change a menu code setting, proceed as follows:
- The „codes" for the menu settings are used to select the various functions in
the balance/scale operating menu. Each code consists of a left-hand
number for the function group (level 1—block) and a right-hand number for
a function within a group (level 2—function).
- Switch balance/scale to the STANDBY mode by pressing the
- In order to gain access to the balance operating menu, remove the
protective cover (114) located on the front right-hand side of the balance/
scale and push the menu access switch to the left.
- When you turn the balance/scale back on by pressing the
simultaneously hold down the
once the readout shown on the left is indicated in the display.
- Then the first level (block) of the balance/scale operating menu will be
indicated.
- To increase the digit displayed for the block, press the
- To decrease the digit displayed for the block, press the
SARTORIUS Portable and Gold
control. Release the
T T
F1
F2
key.
key,
control only
key.
key.
9