Adjustments And Special Procedures; Tool Recommendations; Die Set Position Cradle Adjustment, Centering Punched Holes - Ricoh B234 Service Manual

4. ADJUSTMENT AND SPECIAL PROCEDURES
4.1

TOOL RECOMMENDATIONS

What you need to service the GBC StreamPunch:
1. Standard Measure Tools (English as opposed to metric)
a. Open End Ignition Wrench – ¼" (required only for Chad Kit installation)
b. Nut Driver, 5/16" (optional use Phillips head)
c. Nut Driver, 1/4" (optional use Phillips head)
d. Allen Wrench, 3/32" (comes with Chad Control Kit)
e. Allen Wrench, 5/64"
f. Allen Wrench, 9/64"
2. Other recommended tools
a. Needle Nose Pliers (Side Cutters)
b. E-Prom Extractor Tool – Order under Ricoh P/N VRC11186 (Also used for Plockmatic) or can
be purchased from the following supplier:
SupplierDigi-Key.com
Digi-Key Part Number: K293-ND
Manufacturer Part Number: EX-5
Description: TOOL EXTRACTOR IC PLCC UNIVERSAL
c. Wire Cutters
d. Screw Driver, Phillips Head
e. Screw Driver, Flat Head, Small
3. Supply of Wire Tie Wraps
A nut driver head of ¼" is the most common size for the barrel of a Magnetic or
NOTE:
interchangeable tip screwdriver.
4.2 DIE SET POSITION CRADLE ADJUSTMENT, CENTERING
PUNCHED HOLES
The die set position cradle is set in the factory; however, because of the punched-hole spacing on the
PB die sets, there is a minimal amount of paper on each edge of the punched paper. The die set
position cradle may have to be fine adjusted to center the punched-hole pattern in the paper.
Listed below are the step-by-step instructions to adjust the die set to the proper position:
• The punched-hole alignment must be checked on a piece of punched paper. Fold the punched
sheet of paper in half and the punched-holes should be aligned. If the punched-holes are not
aligned, then the die set cradle must be adjusted to align the punched holes.
The paper path is always constant, if the holes are not centered, you must adjust the
NOTE:
die set cradle.
20