Green Belt Replacement, Paper Exit Side - Ricoh B234 Service Manual

Attach the Docking Plate using "4" Screws.
Step 25:
Attach the Back Rear Cover using the 7 screws (2 for the Entrance and 5 for the Exit
Step 26:
side).
Test the StreamPunch by running 10 copies in bypass mode,
Then 1 sheet in punch mode,
Then 10 sheets in punch mode,
Then 100 sheets in punch model
This entire process takes approximately 60 minutes. First time maybe a little longer.
4.6

GREEN BELT REPLACEMENT, PAPER EXIT SIDE

The following step-by-step directions inform you how to remove and then assembly the components
necessary to access the Paper Exit Side Aligner Green Belt, P/N VRC51019.
It will help you to reference your StreamPunch Service Manual part drawings as you follow this
process.
Special Tools Required:
• Twelve inch metal ruler or similar straight edge.
• Phillips Head Screw Driver 7" or less in total length.
• Alan wrenches.
• Nut Driver
• Rare Earth Magnet Snake Neck (optional – good for retrieving any hardware that happens to fall in
hard to reach spots)
• Snap Ring pliers
• E-Ring tool
NOTE:
Disconnect the StreamPunch from Power. Retain the power cord in your possession for
Step 1:
your safety.
Disconnect the Communication Cable to the Finisher.
Step 2:
Unlatch the GBC StreamPunch from both the Finisher and the Printer.
Step 3:
NOTE:
Open the front door (A) of the StreamPunch.
Step 4:
During assembly, be sure not to over tighten any of the mounting screws.
You must first remove the screw that secures the latch in place (if so
equipped).
AFTER ASSEMBLY
30