Maintenance; Die Set Product Number Listing - Ricoh B234 Service Manual

GBC STREAMPUNCH DIE SET - INFORMATION SHEET
IMPORTANT NOTICE REGARDING THE DIE SETS PLEASE READ
Your GBC StreamPunch die set (C4, W2 and W3 versions), is supplied with a felt pad containing oil, a
pad retaining magnet and shield*. Do not throw these items away!
The felt pad will provide lubrication to the punch pins under normal usage and will help to keep the
punch pins clean. The magnet is intended to keep the felt pad in place during typical handling. If the
pad and magnet came off of this die set during shipping or unpacking, please replace them as
indicated in the accompanying diagram.
Keep this sheet as a reference in the event that the pad and magnet are removed or replaced.
3.

MAINTENANCE

3.1 DIE SET PRODUCT NUMBER LISTING (DIE SET NOT SHOWN)
Die Set repair is not recommended other than to clean and lubricate the Punch Pins. Punch pins are
listed here as a service item only in the event that some may be lost.
If a Die Set produces poor hole quality over time, it is more likely a result of Die Plate wear. In this
case the Die Set should be replaced with a new one.
Felt Pad and Retaining Magnet are not required or included with the 3-Hole, PB or VB
NOTE:
die sets.
13