Ricoh B234 Service Manual page 1294

FINISHER PREPARATION – FOR MT-C3, VC-1
Install the new finisher E-Prom provided.
Replace the Finisher to Printer Cable with the
longer version supplied with the
StreamPunch,
The Finisher Communication Cable and Gray
Inter Connect Cable have been connected
and pre-numbered to assist in installation.
Begin the installation of these cables by first
using wire ties to secure the area labeled "0"
to the new longer Finisher Cable as shown.
Connect the other end of the gray cable
(labeled "1") to the StreamPunch. NOTE: Be
sure the "D" shaped connector is properly
oriented as it is possible to force it on upside
down resulting in no communication.
Attach the 9-pin connector labeled "2" to the
bottom of the finisher board plug CN132(W).
10