Reboot; Reset To Factory - Xorcom XP0120 User Manual

XP0120 Enterprise IP Phone
3. Enter the Current Password, New Password and Confirm password.
4. Click Confirm to save the change.
To change the user password, refer to the steps introduced above.

Reboot

You should reboot the phone when you are challenged, e.g. after applying changes to
the phone configuration.
To reboot the phone via web user interface:
1) Click on Phone->Upgrade.
2) Click Reboot to reboot the phone.
Note:
Please do not power off during reboot, or it will cause the flash memory error.

Reset to Factory

You should reset the phone only in this case: the phone configuration was changed and
the phone is not functioning anymore. To maintain the configuration of the phone, you
need your system administrator or service provider's advice.
To reset to factory via phone user interface:
1) Pres Menu->Settings->Advanced Settings.
2) Enter the password required, scroll to Reset to factory and then press the Enter
hot key.
3) You are prompted to confirm the change, press the OK hot key to reset to factory
settings or the Cancel hot key to cancel.
It takes a few minutes to reset the phone, please do not power off during the
process, or it will cause flash memory error.
Xorcom Ltd.
Using the Advanced Phone Functions
44 www.xorcom.com