Program 711 - Macro Name Programming - Sam4s ER-380 Operation And Program Manual

Program 711 - Macro Name Programming

Program descriptions by typing description on the alpha keyboard overlay or by entering three digit
alpha character codes. To use three digit alpha character codes you must select 'No' in system
option #30 (See "System Option Programming). Also see Descriptor Programming Methods for
Alpha Overlay and/or Descriptor Code Table.
Programming the Macro Name
Up to ten function locations may be designated as Macro keys. You may wish to program a
name for a macro. For example if a macro executes a series of commands to produce daily
reports, you can program the descriptor "DAILY", so the macro can easily be identified.
Macro names can also be helpful when looking at keyboard layout information with the PC
communication utility.
1. Turn the control lock to the PGM-Mode.
2. To begin the program, enter 7 1 1, press the SBTL key.
3. Refer to the chart below and enter the number that represents the Macro key Macro 1
you wish to program; press the X/TIME key.
4. If you are programming using alpha overlay,
three-character codes
5. Press the CASH key to finalize the program.
164 • Program Mode Programming
7 1 1 SBTL
X X/T IME
X Macro Key
1
Macro 1
2 Macro 2
3 Macro 3
4 Macro 4
5
Macro 5
Type up to 18
descriptor keys
or,
Enter up to 18
CASH
X Macro Key
6
Macro 6
7 Macro 7
8 Macro 8
9 Macro 9
10
Macro 10
SBTL
SBTL
ER-380 / ER-380M Electronic Cash Register AU