D-Link DGS-3600 Series User Manual page 30

DPS-200
The xStack DGS-3612 switch can connect an RPS power supply to the Switch (DPS-200) redundant power-supply unit designed
to conform to the voltage requirements of the switches being supported. The DPS-200 is a redundant power-supply unit designed
to conform to the voltage requirements of the switches being supported. DPS-200 can be installed into DPS-900, or DPS-800.
CAUTION:
with installation of the DPS-200.
DPS-900
The DPS-900 is a standard-size rack mount (5 standard units in height) designed to hold up to eight DPS-200 redundant power
supplies.
The RPS can be mounted in a standard 19" rack. Use the following diagram to guide you.
CAUTION: Installing systems in a rack without the front and side stabilizers installed could cause the
rack to tip over, potentially resulting in bodily injury under certain circumstances. Therefore, always
install the stabilizers before installing components in the rack. After installing components in a rack, do
not pull more than one component out of the rack on its slide assemblies at one time. The weight of
more than one extended component could cause the rack to tip over and may result in injury.
xStack DGS-3600 Series Layer 3 Gigabit Ethernet Managed Switch
The AC power cord for the Switch should be disconnected before proceeding
Figure 2 - 6. Installing the DPS-200 into the DPS-900
Figure 2 - 7. Installing the DPS-900 into the equipment rack
14