D-Link DGS-3600 Series User Manual page 258

Figure 10- 1 . Access Rule Configuration window (Packet Content Mask)
To set the Access Rule for the Packet Content Mask, adjust the following parameters and click Apply.
Parameter
Profile ID
Mode
Access ID (1-128)
Type
xStack DGS-3600 Series Layer 3 Gigabit Ethernet Managed Switch
6
Description
This is the identifier number for this profile set.
Select Permit to specify that the packets that match the access profile are forwarded by the
Switch, according to any additional rule added (see below).
Select Deny to specify that packets that match the access profile are not forwarded by the
Switch and will be filtered.
Select Mirror to specify that packets that match the access profile are mirrored to a port defined
in the Port Mirroring window. Port Mirroring must be enabled and a target port must be set.
Type in a unique identifier number for this access. This value can be set from 1 to 128.
Auto Assign – Ticking this check box will instruct the Switch to automatically assign
•
an Access ID for the rule being created.
Selected profile based on Ethernet (MAC Address), IP address, Packet Content Mask or IPv6.
Ethernet instructs the Switch to examine the layer 2 part of each packet header.
•
IP instructs the Switch to examine the IP address in each frame's header.
•
Packet Content Mask instructs the Switch to examine the packet header.
•
IPv6 instructs the Switch to examine the IPv6 part of each packet header.
•
242