Access Profile Table - D-Link DGS-3600 Series User Manual

Click Apply to implement changes made. Currently configured entries will be displayed in the Time Range Information table in
the bottom half of the window shown above.
Access profiles allow users to establish criteria to determine whether or not the Switch will forward packets based on the
information contained in each packet's header. These criteria can be specified on a basis of Packet Content, MAC address, or IP
address.

Access Profile Table

Creating an access profile is divided into two basic parts. The first is to specify which part or parts of a frame the Switch will
examine, such as the MAC source address or the IP destination address. The second part is entering the criteria the Switch will use
to determine what to do with the frame. The entire process is described below in two parts. To display the currently configured
Access Profiles on the Switch, open the ACL folder and click the Access Profile Table link. This will open the Access Profile
Table window, as shown below.
To add an entry to the Access Profile Table, click the Add Profile button. This will open the Access Profile Configuration
window, as shown below. There are four Access Profile Configuration windows; one for Ethernet (or MAC address-based)
profile configuration, one for IP address-based profile configuration, one for Packet Content and one for IPv6 addresses. Users
can switch between the four Access Profile Configuration windows by using the Type drop-down menu. The window shown
below is the Access Profile Configuration window for Ethernet.
The following parameters can be set, for the Ethernet type:
Parameter
Profile ID (1-14)
Type
xStack DGS-3600 Series Layer 3 Gigabit Ethernet Managed Switch
Figure 10- 2. Access Profile Table window
Figure 10- 3. Access Profile Configuration window (Ethernet)
Description
Type in a unique identifier number for this profile set. This value can be set from 1 to 14.
Select profile based on Ethernet (MAC Address), IP address, Packet Content, or IPv6
address. This will change the window according to the requirements for the type of profile.
Select Ethernet to instruct the Switch to examine the layer 2 part of each packet
•
231