Pim Static Rp Settings - D-Link DGS-3600 Series User Manual

Candidate RP
Priority (0-255)
Candidate RP
Wildcard Prefix
Count
Click Apply to implement changes made.
To add a PIM Candidate RP, click the Add button in the previous window, which will display the following window for the user
to configure.
The following fields can be set:
Parameter
IP Address
Subnet Mask
Interface
Click Apply to add the device as a Candidate RP.

PIM Static RP Settings

The following window will display the parameters for the switch to become a static RP. To view this window, click L3 Features
> IP Multicast Routing Protocol > PIM > PIM Static RP Settings.
The following fields can be viewed or set:
Parameter
xStack DGS-3600 Series Layer 3 Gigabit Ethernet Managed Switch
Enter a priority value to determine which CRP will become the RP for the distribution tree.
This priority value will be included in the router's CRP advertisements. A lower value means a
higher priority, yet, if there is a tie for the highest priority, the router having the higher IP
address will become the RP. The user may set a priority between 0 and 255 with a default
setting of 0.
The user may set the Prefix Count value of the wildcard group address here by choosing a
value between 0 and 1 with a default setting of 0.
Figure 8- 87. PIM Candidate RP Settings – Add window
Description
Enter the IP address of the device to be added as a Candidate RP.
Enter the corresponding subnet mask of the device to be added as a Candidate RP.
Enter the IP interface where this device is located.
Figure 8- 8 . PIM Static RP Settings window 8
Description
221