Shoulder Height Markers And A Growing Child - Britax UNITY Instructions For Installation & Use

IMPORTANT :
IF THE BASE IS ONLY FOR INSTALLATION WITH SEATBELT:
• TO BE USED WITH LAP-SASH OR LAP ONLY SEATBELTS IN THE BACK OF
MOST CARS WITH FORWARD FACING SEATS.
• Without ISOFIX compatible connectors; this child restraint is not approved for use
with any connectors that connect to the car's ISOFIX low anchorages.
IF THE BASE IS FITTED WITH ISOFLEX CONNECTORS:
• TO BE USED WITH A LAP-SASH OR LAP-ONLY SEATBELT OR ISOFIX LOW
ANCHORAGES IN THE BACK OF MOST CARS WITH FORWARD FACING SEATS.
• Do not attach the lower attachment connectors of two separate child restraints
to the same ISOFIX low anchorages in your car.
• Always attach the top tether strap to the child restraint and upper anchorage in
your car before each journey.
• Child restraint lower attachment connectors and the ISOFIX low anchorages in your
car are designed to withstand only those loads imposed by a correctly fitted child
restraint.
12
Instructions for Installation & Use - Series No. 40/A/2013

SHOULDER HEIGHT MARKERS AND A GROWING CHILD

NEW BABY
Shoulders below the Shoulder Height
Marker.
Maximum Shoulder Height Marker
FRONT OF VEHICLE
The Infant Carrier is not suitable for your child when
their shoulders are above the shoulder height marker.
If the babies neck muscles are unable to support
their head then the child should remain rear facing,
choose a child restraint that will take larger babies in
rear facing.
DO NOT MOVE TO THE NEXT RESTRAINT UNTIL
SHOULDERS REACHES THE SHOULDER HEIGHT
MARKER.
Instructions for Installation & Use - Series No. 40/A/2013
OLDER BABY
Shoulders in-line with the Shoulder
Height Marker- then you will need to
move to the next child restraint.
Maximum Shoulder Height Marker.
13