Other Accessories - Britax UNITY Instructions For Installation & Use

Infant carrier birth to 12 months (approx.) safe n sound

Hide thumbs Also See for UNITY:

Instructions for installation and use manual (64 pages)

Table Of Contents

Table of Contents

Enlarged version

ACCESSORIES

Use of aftermarket accessories, that is, accessories not provided with this child restraint

can reduce the safety of the child restraint and may cause injury or death. Always

follow the instructions covering the use of accessories in this section or the instructions

provided with accessory. If an aftermarket accessory is used that is not recommended

by Britax then ensure that the accessory is for this restraint compliant with AS/NZS 8005

and stated as suitable for use with this child restraint.

The following instructions apply to accessories that may be supplied with this restraint

at point of purchase. If not, a variety of Safe-n-Sound accessories are available from

various retailers of Safe-n-Sound products.

PADDED INSERT - Style may vary

The Padded insert is only required for supporting

the smaller baby and must be removed once baby's

shoulders reach the upper shoulder height marker

to allow longer use of the Carrier.

A. Disengage the harness buckle and feed the

buckle out through buckle slot in the padded

insert.

B. Remove the insert pad by removing the shoulder

harness straps from the metal strap connector

and feeding the shoulder harness through the

slots. See page 38.

C. Discontinue using the Padded Insert when

shoulder straps are in the top slots or if the Pad

causes over heating, discomfort or you need

more room for baby to grow.

Instructions for Installation & Use - Series No. 40/A/2013

Padded

Insert

Shoulder

Pads

HEAD PILLOW - Style may vary

The head pillow is only required for supporting the

smaller baby and can no longer be used once the

harness shoulder straps are in the top pair of slots.

The pillow is fitted to the carrier by ties on the back

of the pillow being threaded through the next pair of

slots above the harness shoulder strap. Ensure the

ties are threaded through slots in the backrest of the

main moulding and tied together.

CANOPY

Refer to page 24.

SHOULDER PADS - Style may vary

The shoulder pads may require release by press studs. If fully fitted to the shoulder strap

then you will need to disconnect the shoulder strap as described on page 38.

EXTRA BASE

An Extra Base is available as a separate

purchase for a second car. These bases can

mean that the Carrier can be easily and quickly

switched between cars. An extra top tether strap

is supplied with the Base.