Using The Infant Carrier - Britax UNITY Instructions For Installation & Use

SUITABLE FOR USE
THE TETHER STRAP MUST ALWAYS BE FITTED WHEN THE CHILD RESTRAINT IS
USED IN A VEHICLE.
Do not use the restraint without the top tether strap correctly attached.
The top tether strap must be attached to an anchorage point using an extension strap if
necessary.
The Infant Carrier may just touch the front seat, but must not in such a way that the
installation angle is affected.
Do not recline the seat excessively, it must be installed at the correct angle (see page
25 - 26).
Do not use on any vehicle seat which faces sideways or rearwards.
DO NOT USE A REAR-FACING CHILD RESTRAINT WHERE AN AIRBAG IS FITTED
IN FRONT OF THE SEATING POSITION. For other airbags, refer to the car owner's
handbook for warnings and instructions.
Seat belt extenders should not be used if the seat belt is not long enough to secure the
child restraint. If seatbelts are too short the advise should be sought from a child restraint
fitter and thier recommendedations considered before using a seatbelt extender. If they
are used then the buckle must sit above the base moulding.
20
Instructions for Installation & Use - Series No. 40/A/2013

USING THE INFANT CARRIER

REMOVING INFANT CARRIER FROM BASE
A. Grasp the handle with one hand. With the other
hand, lift the catch located at the front of the Infant
Carrier.
B. With the catch still lifted raise the Infant Carrier
clear of the base.
Instructions for Installation & Use - Series No. 40/A/2013
Lift
Pull
Catch
21