Britax UNITY Instructions For Installation & Use page 37

TRAVEL SYSTEM
BRITAX CLICK & GO™ADAPTOR
HOW TO REMOVE THE BRITAX
CLICK & GO™ADAPTOR
To remove the Britax Click & Go™ Adaptor,
ensure handle is in "rocking position"
Cover removal is not necessary.
A. Unclip the two infant carrier cover elastic
straps which are secured by a plastic hook
under the handle pivot.
B. Gently unscrew the Press Pin and remove.
Pull out the locking pin and carefully
remove the adaptor from carry handle.
Pull out Locking Pin
C. Store for future use with these instructions.
72
Instructions for Installation & Use - Series No. 40/A/2013
Unhook
2
. elastic
underneath
the adaptor
Pull down away
from under handle
BRITAX CLICK & GO™ADAPTOR
HOW TO REPLACE THE BRITAX CLICK & GO™ADAPTOR
A. To attach the Britax Click & Go™ Adaptor to the Infant Carrier ensure the Carrier's
Handle is in "Rocking position" , disconnect the elastic under the handle boss and
2
pull the trim away from the side of the carrier to align the holes.
B. Align the Adaptor in the recess under the handle
boss, push up and click into place.
C. Insert Locking Pin into hole. Align both top and
bottom holes.
D. Then push the Press Pin in the bottom hole and
push into place.
Instructions for Installation & Use - Series No. 40/A/2013
TRAVEL SYSTEM
2
B
Push in under handle
C
Push in Locking Pin
D
Push in Press Pin
73