Buckle Operation - Britax UNITY Instructions For Installation & Use

CARE & MAINTENANCE

BUCKLE OPERATION

To ensure the buckle remains operational the inside of the buckle must be kept free of
liquids, sand, dirt, fluff, food or similar substances. If the buckle is not operating or you
do not hear a strong audible click when second tongue is inserted then the buckle needs
to be washed or replaced. The buckle is fully engaged when both tongues are inserted .
Contact Customer Service for assistance.
TO CLEAN HARNESS BUCKLE:
If sticky liquids such as baby formula, fruit juice, etc. get
inside your harness buckle, it may become sluggish. An
indication of a sluggish harness buckle is that you cannot
hear a click when engaging the last harness tongues. To
restore the harness buckle to good working order it needs to
be cleaned as follows:
A. Remove the harness buckle from the restraint: From the
underside of the restraint pull each crotch strap 3-bar
slide, turn the 3-bar slide on its side and push back
through the slot.
B. Place the harness buckle under warm (max. 40 degrees
Celsius) running water as shown below. Let the water run
through the mouth of the buckle for five minutes. Check
the harness buckle is clean by engaging the harness
tongues and buckle several times until you hear a click.
C. If you still cannot hear a strong audible click then repeat
the cleaning process several times.
D. Refit the harness buckle to the restraint ensuring the red
button facing outwards and the 3-bar slide is fed through
the same slots.
If the Harness Buckle cannot be returned to its
original working condition then contact BRITAX
Customer Service for assistance.
52
Instructions for Installation & Use - Series No. 40/A/2013
Cover
Body
3-bar
A
slide
B
Click
C
CARE & MAINTENANCE
COVER (STYLE MAY VARY)
The restraint has a flame retardant cover which is removable for cleaning. Cleaning
instructions are on the care label attached to the cover. If fluffy cover is fitted then
washing the cover prior to use will remove excess fluff.
The cover has been designed to protect your child when seated in the restraint. Care
should be taken if children either eat or drink while in the restraint as some food or drink
products may cause damage or marking to the cover. Wash or clean immediately.
Do not pull sticky items from covers as the cover may be damaged - soak in water and
gently remove.
VERY IMPORTANT:
Only replace the cover with Safe-n-Sound
supplied replacement cover with identical
shoulder height markers or a replacement
cover meeting AS/NZS 8005.
ONLY USE BRITAX SAFE-N-SOUND SEAT COVERS AND ACCESSORIES THAT
ARE DESIGNED AND TESTED FOR USE WITH THIS PRODUCT.
Instructions for Installation & Use - Series No. 40/A/2013
53