Britax UNITY Instructions For Installation & Use page 16

HOW TO INSTALL - TOP TETHER STRAP
IMPORTANT :
The Top tether strap must be fitted at all times when the baby is in the car when
using either the seatbelt or the ISOFLEX connectors.
Always secure the loose end of the top tether strap to prevent it hanging out of the
car or being accessible by the child.
THIS RESTRAINT IS NOT SUITABLE FOR USE WHERE THE TOP TETHER
STRAP MAY FALL INTO A SPLIT IN THE SEAT BACK OR OFF THE SIDE OF THE
SEAT.
Always ensure that the car seatbelt and top tether strap are firmly restraining the
restraint on the vehicle seat.
ALWAYS ATTACH TOP TETHER HOOK AND REMOVE SLACK IN THE TOP
TETHER STRAP.
CAUTION:
CHILDREN CAN BE INJURED OR RESTRAINTS AND TOP TETHER STRAP
DAMAGED BY UNSECURED CARGO IN A COLLISION. SECURE OR REMOVE
HAZARDOUS CARGO BEFORE USING THIS CHILD RESTRAINT.
REMOVING THE BASE FROM THE CAR
When removing the base, release the attachment clip from the car's upper anchor fitting
then remove the seatbelt or remove ISOFLEX low anchorages.
30
Instructions for Installation & Use - Series No. 40/A/2013
HOW TO INSTALL THE BASE -
WITH ISOFLEX™ CONNECTORS
WHAT ARE ISOFIX LOW ANCHORAGES IN A VEHICLE?
ISOFIX low anchorages are fixed, standardised anchoring points for securely installing
an ISOFIX compatible child restraint in a vehicle with ISOFIX low anchorages.
It has now become an international standard for vehicles. This anchoring technology
minimises installation mistakes by optimising the protective effect of a solid connection
between vehicle and ISOFIX compatible child restraint.
INSTALLING THE BASE INTO THE CAR
(USING ISOFLEX CONNECTORS IF FITTED)
To prevent damage to vehicle seat it may be necessary
to remove or open a trim covering the ISOFIX low
anchorages.
A. Locate the ISOFIX Low Anchorages in the vehicle
seat bight. The location may be identified by one of
the following symbols, or the anchorage bars may
be visible.
If you cannot locate them, check your vehicle owners manual.
B. If necessary, clip the two insertion guides to the two ISOFIX fastening points of the
vehicle seat (between seat and backrest). Tab must be upwards. Allow the guides to
rise so they hook on to the ISOFIX low anchor bars. The guides are provided to allow
easier alignment of the child restraint. The guides are not required where anchors
are visible or there are already guides provided in the vehicle seat.
Instructions for Installation & Use - Series No. 40/A/2013
ISOFIX low anchors in the
vehicle seat
Insertion guides
31