Installing The Base - Britax UNITY Instructions For Installation & Use

USING THE INFANT CARRIER
TO FIT AND USE THE CANOPY
A. With the viewing window flap on the outside,
grasp the Canopy ensuring the two plastic
frame sections at both sides are aligned.
B. Push the two plastic frame sections at both
sides onto the Infant Carrier at the inside of
the handle pivot.
C. Refit the elastic Canopy strap to the
dedicated elastic trim strap on each side of
the Infant Carrier.
NOTE: Elastic Canopy loops must always be
fitted when Canopy is in use.
D. The Canopy can be rotated to cover the
baby or folded by rotating to the desired
position.
TO REMOVE CANOPY
A. Ensure Canopy is in the collapsed position.
Unclip the elastic Canopy straps which are
secured by plastic hooks under each handle
attachment point.
B. Grasp the Canopy and pull it away from the
Infant Carrier ensuring the straps are clear of
catching any objects.
24
Instructions for Installation & Use - Series No. 40/A/2013
INSTALL INTO VEHICLE
Remove all packaging from the Infant Carrier. Remove the ISOFIT insertion guides
(page 18, Ref 31) from the supplied location and store safely for further use.
Consult the car owner's handbook for location of top tether anchorage points.
If there is no child restraint anchor fitting or child restraint anchor point refer to pages 58
to 62 for the installation of the anchor fitting as well as the use of extension straps.
An anchor fitting is required to attach the top tether strap to fully install the Carrier to the
A
car. The top tether strap must be used with this infant carrier when used in the car.
For installing the Base to the car, select a seating position with a child restraint anchor
fitting directly behind the seating position.
ADJUSTING THE BASE ANGLE
A. Place the base and Infant Carrier on vehicle seat
in a seating position where a child restraint anchor
fitting is installed. The Level Indicator Line needs
to be level with the road, (i.e. parallel with the road
surface). Check and adjust the Levelling knob of
the base if necessary.
B. If your car's seat is contoured then you may need
to adjust the angle of the base so your baby is not
too upright.
The angle may be altered by turning the base
levelling knob located at the rebound bar end
which will cause the levelling foot to extend from
the under side of the base.

INSTALLING THE BASE

Level Indicator Line on
both sides of base.
Instructions for Installation & Use - Series No. 40/A/2013
Levelling Knob
25